This topic is a chance to discuss more about the best practices for vPC and Fabricpath technologies applied on Data Center networks. This session will provide you with a better understanding of design and configuration aspects, as well as more insights on troubleshooting methodologies and tools for these features.
Ask questions from Monday 3rd to Friday 14th of September, 2018
Roxana Stegaruhas been a Customer Support Engineer in Data Center Switching team in Brussels since September 2015. She assists customers to restore network down situations in a timely manner working preponderantly with Nexus platforms and Data centre technologies: vPC, Fabricpath, OTV. Also, she has participated in several internal mentoring programs within Cisco. Roxana holds a Bachelor’s degree in Electronic Engineering, telecommunication and IT from the Military Academy in Romania. She holds a CCIE Certification in Data Center ver 2 (#58144).
Michalis Stylianouhas been a Customer Support Engineer for the TAC Data Center Switching team in Belgium since February 2016. He has experience in switching and vast knowledge about almost the whole Nexus portfolio. He specializes on vPC, OTV, FabricPath, VxLAN and NDB solutions. He holds a Master’s degree in Communications Networks and Software and a CCIE in R&S and one in SP (#42673)
Roxana and Michalis might not be able to answer each question due to the volume expected during this event. Remember that you can continue the conversation on the Data Center community.
HiI have a small PoC to do where I need to connect a private DCI to a Cisco switch. Since this is a PoC, I really need something basic (and the least expensive possible) that supports VxLAN and EVPN with 10G ports. I would actually need only 2 ports ...
Hello,I have 4k catalyst connected to 6k catalyst through multi-mode fiber and 10gb-lx4 gbic, i want to replace the 4k catalyst with 9k catalyst, what is the recommended sfp to connect 9k catalyst with 6k catalystThanks,
I have different design questions about ACI. When should I use different AEPs?In which case should I connect a Firewall/Loadbalancer with L3OUT or L4/7 Serivcegraph?Which advantages do I have with L4/7 Serivcegraph unmanaged?Is ther...
Any specific reason why a Port-channel cannot be used as destination for local SPAN configuration on ACI?
I need to mirror traffic from a vPC (2x10G) and the only option for local SPAN is to use a single 10G access port as destinatio...
Hi,After providing the VTEP pool /16 assignment to apic, by default what interfaces are created, as i can see l0, l1, l1023?Also how do i check the loopback 0 and loopback 1 IP address of leaf switches from APIC CLI ?.