HelloCan you please tell me what is the best Upgrade combination possible for my Actual setup.Switch#sh moduleMod Ports Card Type Model Serial No.--- ----- -------------------------------------- ------------------ -----------1 48 CEF720 48 port 1000m...
Forum Posts
I currently have a network that connect the data center 01 to HQ 01 using 1 link with the the IPADDR scope of 10.10.254.0/24. I typically would think that this should be a point to point link /30 but that is why I am asking for a discussion. What is ...
ooking for a Power distribution Unit PDU to support a Cisco 9508 that has 8 power supplies,I attached the hardware reference guide. The wattage used is dependent on the supervisor and line cards in the switch. Initially we have 2 Supervisor B+ (N9K-S...
I have three DCs that I am preparing a configuration for. The plan is to use ISR4000-series routers and interlink the three sites with OTV. Initially was planning on using the Unicast-OTV mode. Staging a simplex setup, with no redundancy yet. Mapped...
I just got a Cisco Catalyst 2960 and am trying to get my network running.2 problems1) My computer is hardwired to the switch-I can get access to a few websites (eg gmail; outlook mail) but most others I can't connect to - just times out 2) I have 3 N...
Is the PoE voltage on the SG300 28PP ports floating from mains power plug ground or not?
Hi, I am looking to see if it's possible to deploy an F5 Loadbalancer within a VxLAN 9000 deployment which is not running ACI? Is there so Cisco deployment guide or any other guide which someone can recommend. I was planning on using a border lea...
Hi,I am designing power feed for IT racks that include your products.for example, let's take the c9300-48 UXM-A.it is specified in Table 18 on the datasheet, that the power supply's (PWR-C1-1100WAC) input current is 6A (240VAC)which means that the i...
Hi All, Just wondering if someone has any information on what will happen if this command is NOT on one SVI that is extended between DCs. The other side of the tunnel does have it configured. Thanks!Jacques
Hello,We purchased, C9200-24T , that currently runs with evaluation license. It is understood that smart licensing should be enabled before expiry of eval licensing (starting with code 16.9.1) . However i would like to know what happens if i did not ...
Hallo,I have got a question about this switch. We make a schoolprojekt about the WLAN illumination of our school. The problem is that we can´t find the significant technical aspekts about this switch in the datasheets. It would be very helpfull if so...
Hello!Dear sirs. I make two small datacenters and want to use VXLAN tunnel over L3, link between them.In each DC I have two switches and VRRP virtual IP as default gateway.But if I have single address space in both DC, what is best practice for this ...
I am looking at pros/cons of using Catalyst 9k (9500) as Layer 3 switch for DC. We currently have Nexus 9500 in DC as layer 2 & 3 but there has been serious issues with Nexus stability and reliability during maintenance and software upgrades. We run...
