Data Center Switches

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Save 25% on Day-2 Operations Add-On License

 

Forum Posts

Hi Folks,In our data center design, We implemented a new VRF design to segregate the traffic and increase the capacity for specific traffic. So we have configured the 3 sub-interface. Ex Eth 1/49.234 Eth 1/50.234 Eth 1/52.234. We would like to know t...

Hi  We have A nexus 7009 switch that is just running as a single unit with just routing and only admin vdc and one prod vdc and  no vpc,fabric path etc on it . My question is can we replace the M2 and F2 line cards below with new F3 line cards as is ...

ervindm by Level 1
  • 907 Views
  • 0 replies
  • 0 Helpful votes

I have a question around Nexus 9k where Tunnel keepalives are not supported for GRE tunnels. We are having an issue wherein the tunnel seems to be down on several instances as the other end of the tunnel isnt reachable. But due to keepalives restrict...

RD82 by Level 1
  • 688 Views
  • 1 replies
  • 0 Helpful votes

Hi All,Just sharing an issue we encountered while our team was configuring a customer VxBlock System 1000.  Nexus 9336C-FX2 running 7.0(3)I7(6)QSFP-100G-SR4-S Transceiver (Avago AVG* Serial number)Port 1/29 & 1/30 breakout set to 25g-4xMTP to 4 Duple...

eric-daly by Level 1
  • 1352 Views
  • 0 replies
  • 0 Helpful votes

I have a question around Nexus 9k where Tunnel keepalives are not supported for GRE tunnels. We are having an issue wherein the tunnel seems to be down on several instances as the other end of the tunnel isnt reachable. But due to keepalives restrict...

RD82 by Level 1
  • 574 Views
  • 0 replies
  • 0 Helpful votes

I have a question around Nexus 9k where Tunnel keepalives are not supported for GRE tunnels. We are having an issue wherein the tunnel seems to be down on several instances as the other end of the tunnel isnt reachable. But due to keepalives restrict...

RD82 by Level 1
  • 658 Views
  • 0 replies
  • 0 Helpful votes

We have a paging system (Cisco CCUM) that sends broadcast messages to speakers using multicast. Sometimes we are unable to hear the audio in some speakers or we only hear a part of the messages. We have a 10Gig network - We do not think that it is la...

Hi Team,   I am upgrading nexus 3k by running install all command and have put "show lacp issu-imapct" as pre-check. The issue is show lacp issu-imapct is giving me some ports which are not issu ready which means I have to either disable lacp fast on...

asinghi by Cisco Employee
  • 943 Views
  • 1 replies
  • 0 Helpful votes