cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
69
Views
0
Helpful
0
Replies

breakout cable design in DC

Ezzedine
Level 1
Level 1

hello,

I would be grateful for any feedback on the design.
I wonder if I might ask your advice on the following: I have two N9K-C9332D-GX2BX in two separate rooms, which are interconnected with OM4.
I believe the best solution would be to use a QDD-400G-SR4.2-BD breakout cable to connect to the other room, the peer switch and another storage system.

According to the optic-to-optic guide, it seems that either a QSFP-100G-SR1.2 or a QDD-400G-SR4.2-BD may be suitable.

I am wondering if it would be possible to use a breakout cable to connect the peer device in the other room and the storage system that has a different SFP100G vendor. I will use another Breakout cable for redundancy, but I would be very grateful for any advice on whether this is a valid approach. I would also be very happy to hear any suggestions for improvements.


Drawing1.jpg

0 Replies 0

Review Cisco Networking for a $25 gift card