I am trying to setup Cisco N1K on a vCenter 5.5 using L3 mode, however it shows on the ESX host that it only supports L2 and the port group shows as blocked by Admin.
In the basic setup I have used L3 mode in the Ethernet port-group I am using trunk mode and in the veth port-group I am using capability L3control .
I am looking for a solution where I am going wrong?
Go to Solution.
I got this resolved after doing two things:
a) switch(config-svs-domain)# control type multicast
b)VEM modules will not register to the VSM before a vmkernel interface (vmk) is migrated to a Layer3 Control capable port profile.
(Once a vmk was migrated to this switch - it all lighted up for me !)
View solution in original post
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: