L3 Port-Channel To NX7K vPC Domain

[zekebashi]

Hello, 

We are considering changing the current vPC configuration of our access-layer switches from L2 to L3. They are currently attached to single-sided vPC domain via L2 Port-channel.

According to the below Cisco document, NX7K doesn't support attaching a end-device to a vPC domain using L3 port-channel. Does NX7K support L3 port-channel?

Page 38of 129

Page 46of 129

https://www.cisco.com/c/dam/en/us/td/docs/switches/datacenter/sw/design/vpc_design/vpc_best_practices_design_guide.pdf

Thanks in advance, 

~zK 

[zekebashi · Accepted solution]

I think I found the answer. Yes, L3 over vPC is supported on the NX7K depending on the module model and sw code installed on the vPC peers. Here's the Cisco document: 

https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus7000/sw/interfaces/config/cisco_nexus7000_interfaces_config_guide_8x/config-vpcs.html#concept_F862A25175DE4C738065F0EDA6F5D8C0