cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Community Helping Community

783
Views
0
Helpful
1
Replies
Highlighted
Beginner

Logging into the vNAM on the Nexus 1010

I have two Nexus 1010 appliances installed in resilient configuration that are currently running a resilient virtual supervisor module. I have recently installed the virtual network analysis module (vNAM) but I am unable to login to the vNAM command line to install the license. When I connect to the vNAM from the Nexus 1010 the following occurs:

# login virtual-service-blade <<VSB name deleted>> primary

User Access Verification

Enter passphrase for key '/var/home/admin/.ssh/id_rsa':

Enter passphrase for key '/var/home/admin/.ssh/id_rsa':

Enter passphrase for key '/var/home/admin/.ssh/id_rsa':

Password:

Password:

Password:

Received disconnect from 127.1.1.1: 2: Too many authentication failures for _cisco_vsb2

The vNAM documentation suggests that I should receive a "username" prompt and that the default username and password are both "root". Needless to say I have tried entering a variety of things for the prompt shown above including the default username/password.

I'm sure I am missing something here somewhere .... but is anyone able to help?

Everyone's tags (2)
1 REPLY 1
Beginner

Logging into the vNAM on the Nexus 1010

Is the Nexus1010 setup just upgraded to SP1(2) release. There is a bug which was release noted in SP1(2) release notes that after upgrade to SP1(2), the user have to reload once again to be able to login  to VSBs on standby

CreatePlease to create content
Content for Community-Ad
FusionCharts will render here