Re: nx os upgrade and system version

moosas001 · ‎05-16-2021

Hi,

I upgraded from nxos.7.0.3.I4.7.bin-nxos.7.0.3.I7.9.bin-then nxos.9.3.7.bin

but still the system version shows "System version: 7.0(3)I7(9)"

Please advise

Thanks
Software
BIOS: version 08.38
NXOS: version 9.3(7)
BIOS compile time: 05/12/2020
NXOS image file is: bootflash:///nxos.9.3.7.bin
NXOS compile time: 3/10/2021 3:00:00 [03/10/2021 16:39:29]

Hardware
cisco Nexus9000 C9508 (8 Slot) Chassis ("Supervisor Module")
Intel(R) Xeon(R) CPU E5-2403 0 @ 1.80GHz with 16399356 kB of memory.
Processor Board ID SAL1909A7V8

Device name: sw1
bootflash: 51496280 kB
Kernel uptime is 0 day(s), 22 hour(s), 45 minute(s), 57 second(s)

Last reset at 150509 usecs after Sat May 15 19:24:40 2021
Reason: Reset due to upgrade
System version: 7.0(3)I7(9)
Service:

julian.bendix · ‎05-17-2021

Hey!

The info block below "Last reset" shows you the status before the last reload.

The given output shows you that the last reload reason was "upgrade" and the version BEFORE the reload was 7.0(3)I7(9) ..

So this is OK and expected.

Best regards
Juls

Sergiu.Daniluk · ‎05-28-2021

Software
BIOS: version 08.38
NXOS: version 9.3(7) -> the version currently running on your switch
BIOS compile time: 05/12/2020
NXOS image file is: bootflash:///nxos.9.3.7.bin
NXOS compile time: 3/10/2021 3:00:00 [03/10/2021 16:39:29]

Hardware
cisco Nexus9000 C9508 (8 Slot) Chassis ("Supervisor Module")
Intel(R) Xeon(R) CPU E5-2403 0 @ 1.80GHz with 16399356 kB of memory.
Processor Board ID SAL1909A7V8

Device name: sw1
bootflash: 51496280 kB
Kernel uptime is 0 day(s), 22 hour(s), 45 minute(s), 57 second(s)

Last reset at 150509 usecs after Sat May 15 19:24:40 2021       -> last time when the switch was restarted
Reason: Reset due to upgrade                                -> reason why the switch was restarted (could be a reload command, an upgrade, or a crash)
System version: 7.0(3)I7(9)                                     -> version running before the switch restarted
Service: