Hello All I am new to CISCO. Recently we bough new SAN CISCO 9706
directors. I am trying to understand which part of these directors are
FRU and which one are CRU. Do anyone has any document reflecting it for
this directors. Reagrds Amit
in My Videos)This video shows you how to reset a lost admin password on
an MDS running NX-OS.For this video we used an MDS-9124, but the
procedure will work on any device running NX-OS !!! Warning: This
procedure is disruptive, it reloads/powercycle...
Is there anything special I have to do on VMware to get two 9000v's setup as a vPC pair? When I build the vPC, the link will come up and then throw the log up below and block all VLAN's from traversing the peer-link. If I put the same config o...
Dear friends, I am struggling to understand difference between extending EPG vs extending BD in normal SINGLE POD case-1 As i understood so far, Extending EPG means we will make EPG-10 and will add trunk ports in it (trunk port going ...
This may be the wrong place to post this question but I'm having a weird issue accessing the APIC GUI from my home internet. When on my ISPs service, I cannot access the GUI of any of my companies APICs. I can only ping the APIC IP with a max MTU size of ...