Cisco Data Center Overlays with focus on VXLAN (Virtual Extensible Local Area Network) (Live Webcast October 20th)
During this live event, Cisco subject matter expert Vishal Mehta will share about Cisco Data Center Overlays with focus on VXLAN (Virtual Extensible Local Area Network). In the modern data center, traditional technologies are limiting the speed, flexibility, scalability, and manageability of application deployments. There is emerging interest in the industry in overlay technologies (such as MPLS, VXLAN, LISP...) which may address some of these challenges. This session will discuss the latest trend in Overlay Technologies and compare each one of the available solutions in terms of deployment, benefits and challenges. The major emphasis in this session will be on VXLAN evolution and to elaborate on which Cisco Products support different VXLAN solutions. Various VXLAN configurations such as BGP-EVPN control plane, L2 Gateway, L3 Gateway; Bridging, Packet-Flow, Best Practices, Deployment scenarios and other advanced features will be also discussed.
Vishal Mehta (Read the Interview) is a Technical Marketing Engineer with Cisco's Data Center Competitive Insights Team based in San Jose, California. Previously he was working as the customer support engineer for Data Center Server Virtualization Technical Assistance Center (TAC) team for the past 4 years with a primary focus on data center technologies such as Cisco Nexus® 5000, Cisco UCS, Cisco Nexus 1000V, and Virtualization. He has CCIE® certification (# 37139) in Routing/Switching, Service Provider & Data Center. Vishal has presented at Cisco Live in Orlando 2013, Milan 2014, and San Francisco 2014 (BRKCOM-3003, BRKDCT-3444, and LABDCT-2333).
Need some advice about the design, will it work.Please refer to attached diagram. N7K-1 and N7K-2 interconnect on port-channel 1 running fabricpath.N7K-3 and N7K-4 interconnect on port-channel 1 running fabricpath. Host A on VLAN190 ...
Hello, Could you check out my config template, I just want to make sure that it makes a domain and works properly, I am about to put it on a production. thanks a lot 5k-1#Config T
5k-1(Config-Fex)#Pinning max-links 1
Hi, Could anyone here please help clarify if I can configure either BIOS of Cisco 12G SAS Raid bios to have a standard SATA hard drive access? I am having a Cisco C220 M4 server with Cisco 12G SAS raid controller...
Hi,The APIC EP tracker does not give results when searched with VM name.FYI: Getting results when searched with same IP address.Has anybody tried this ? The tool tip shows as:e.g., 00:50:56:BD:2E:6C, 10.0.0.1 or 2002:50:22:0:50::1, or comp-vm1APIC ve...
I have 2 x 7009 chassis, each have 2 x SUP1 supervisors (NXOS 6.2(16)), 3 x M108X2-12L, 1 x M148GT-11L line cards and 5 x FAB2 fabric modules. These act as the core switches, with VPCs to downstream Nexus 5500s.I need to replace the modules in each 7009 w...