The video is to show the HUU upgrade process in action for those who want to see the process before implementing. It shows CIMC, BIOS, and P81E being upgraded individually. It has been shortened for time.
Applying the PSU firmware will require the power be momentarily removed, when prompted, from the PSUs to complete the upgrade.
The screen may go blank because of a screen saver, press any key to recover screen.
Hello.I never run Nexus Swithes...So, I have a few questions. In an environment configured with a VPC Can the traffic of the Orphan port connected to the bottom be forwarded through the peer link??? (I wonder if it works like Catalyst's Inter-link.) ...
hello, i tried to find a document describing it but was not successful. i understood that on an ACI witch a BD and one EPG is always consuming an internal VLAN. maximum numbr of vlans is 3964 (or similar). therfore you can approx copnfigure 1980 EPGs...
Hi, For a UCS customer can I use 93360 and provide both IP and SAN networking in a converged infrastructure deploymentBasically UCS+FI is connecting to 93360 (instead of 93180+MDS) for internet and SAN array Thanks & Regards,Sreeram
Hi community, I have a case where we have a typical MultiPod deployment (2 Spines connecting to 2 IPN devices at each site, 2 IPN devices connecting to each other and connecting to the other sites via P2P). The dedicated IPN is configured to support ...