Valid BPDU interval based on "show spanning-tree vlan <vlanid>"
I have attached the result of running "show spanning-tree vlan 200" command here from a screenshot I have. The question is based on Fa0/3 Altn port status then this switch must be running Rapid STP which means every switch including root bridge sends out BPDU hence in this case average Hello time is every 2 seconds, forward delay of 15 seconds and the time spent in learning mode is 15 seconds.
Is this true or root bridge trumped local configuration and BPDU is sent out every 10 sec while switch remaining in learning state for 30 sec?
This International Programmers Day we are shining the spotlight on our developer community in Latin America. Get ready for #CiscoLiveLA with #DevNet!
Join us live and we'll take your questions during the broadcast or after if you post to the com...
Join us on Thursday, September 12 at 10 am PT for International Programmers Day. We are shining the spotlight on our developer community in Latin America. Get ready for #CiscoLiveLA with #DevNet!
Post your questions below in the comments.
Join us for a live presentation on Thursday, July 25 at 10 am PT. We'll be talking about Cisco DevNet Automation Exchange, which provides shared code repositories for network automation and guides teams through their journey with a walk-run-fly meth...
Join us for #CiscoChat live on Thursday, May 23 at 10 am PT
Cisco Live, San Francisco 2014 … Were you there? We are celebrating 5 years of the iconic DevNet Zone! With more content, more experts to help you in your learning journey, and more opport...