I've reserved the ACI Hardware Lab twice over the last 24 hours and both times the lab came up with no Leaf/Spine nodes being detected from the APIC. I am able to VPN in just fine and log into the APIC at 10.10.20.42. Once in the APIC, there are no nodes showing up in Fabric Membership in the GUI. The APIC does however see a leaf connected on 2-1 via LLDP:
admin@apic1:~> acidiag run lldptool in eth2-1
Chassis ID TLV
MAC: f8:c2:88:91:03:c3
Port ID TLV
Local: Eth1/1
Time to Live TLV
120
Port Description TLV
topology/pod-1/paths-104/pathep-[eth1/1]
System Name TLV
Leaf4-104
System Description TLV
topology/pod-1/node-104
System Capabilities TLV
System capabilities: Bridge, Router
Enabled capabilities: Bridge, Router
Management Address TLV
MAC: f8:c2:88:91:03:c3
Ifindex: 83886080
Cisco 4-wire Power-via-MDI TLV
4-Pair PoE not supported
Spare pair Detection/Classification not required
PD Spare pair Desired State: Disabled
PSE Spare pair Operational State: Disabled
Cisco Port Mode TLV
0
Cisco Port State TLV
2
Cisco Serial Number TLV
SAL18432WL7
Cisco Model TLV
N9K-C9372PX
Cisco Firmware Version TLV
n9000-13.1(2v)
Cisco Node Role TLV
1
Cisco Infra VLAN TLV
4094
Cisco Name TLV
Leaf4-104
Cisco Fabric Name TLV
ACI Fabric1
Cisco Node IP TLV
IPv4:10.0.224.64
Cisco Node ID TLV
104
Cisco POD ID TLV
1
Cisco Appliance Vector TLV
Id: 1
IPv4: 10.0.0.1
UUID: 86020d94-4f2c-11ea-baf3-bbc55e1f252a
End of LLDPDU TLV
Interesting that it already has a Name, NodeID, and IP address. Seems like there is some previous configuration hanging around, possibly a clean script is not completing? Can someone from Devnet support please check this and let me know?
