I've had this problem from the beginning. After a dozen repetitions, I've recently realized that it's not something I'm doing wrong, but that there's something wrong with our accounts or with the system: I reserve a lab.I add to "allowed users" the o...
Forum Posts
Hi all, it's the first time I have reserved a devnet sandbox. This morning I recieved an email telling me that provisioning will take around 15min more minutes and that I would receive an additional email with the anyconnect credentials.After two hou...
Can't connect to UCM in intersight Sandbox even when vpn is connected. I have dropped and reconnected vpn several times and rebooted. Should be able to browse to UCM addresses 10.10.20.40 & 10.10.20.50 once VPN is connected.
Hi I have received email for reserving lab IOS XE for catalyst 9000 successfully but cannot connect the vpn. Can you help to check ? Your Lab private VPN connection information:Lab Network Address: devnetsandboxsj.cisco.com:20346Username: cm6043Thank...
What are the cred for UWM portal ?I tried virl/VIRL. But no luck.
I have created UCCX 11.5 many times have been able to access the admin site at UCCX Administration: https://hq-uccx.abc.inc many times. Today I am getting "hq-uccx.abc.inc took too long to respond.". I can connect to all of the other sites on the la...
Do VIRL support SNMP ? If I reserve Multi-IOS Cisco Test Network in devnet will the simulated devices respond to SNMP walk?If not then what is the process to enable SNMP on VIRL devices? Please help me if anyone configured SNMP on VIRL before.
Hello,I'm trying to setup SNMP access to APIC, but without any success.I follow this guide: https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/1-x/mib/guide/b_Cisco_ACI_MIB_Quick_Reference/b_Cisco_ACI_MIB_Quick_Reference_chapter_01...
Hi Admin/Support, I've tried a couple of times to end/re-start new sessions but VIRL server cannot complete setup process and lab status is Active (with Error). Seems VPN setup is also not completed when setup process is not properly completed and I ...
Hi there, I have just started up the TRex sandbox and connected to it via AnyConnect. But when I try to follow the instructions and SSH to the TRex or the CSR1000v, Guacamole just gives me an connection error. Any suggestions?
I tried to establish VPN connection to Room Kit CE 9.6 sandbox with the following Lab Network Address: devnetsandbox-emea-gwy.cisco.com:20198. However, I always get this prompt " Connection attempt has timed out. Please verify Internet connectivity....
Hi All, Is anyone aware that the Multi-IOS VIRL not being available for the past hour or so. On a separate note I am also having difficulties connecting to the VPN I wonder if the two are linked - have got the correct logons for a reserved session bu...
Hi, How to execute scripts with root access on nexus switches? Thanks & regards,Nilesh
Hello, I testing SandBox of Cisco DNA Center Lab 2. I want to access that switch device with PuTTY SSH. For example like C3850_B(10.10.20.80). When I connect PuTTY SSH with 10.10.20.80,PuTTY console was opened and can see like this.------------------...
Hello, I've reserved a sandbox "Room Kit 9.3" Scenario so i could try out the "Introduction to xAPI for Cisco collaboration devices". The lab is active but I'm yet to receive any e-mail regarding VPN connection. Is there a way to resend the infor...
