cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
437
Views
0
Helpful
3
Replies

How to enable devices on Cisco SDWAN Sandbox 19.2now

shahid_jambagi
Beginner
Beginner

Hi Team,

How to enable other devices on the Sandbox highlighted and marked with red, please do let me know if pointers?

3 Replies 3

bigevilbeard
Collaborator
Collaborator

@shahid_jambagi is this the always-on SD-WAN sandbox or the reservable SD-WAN sandbox? In both there should be no requirement to bring up the vEdge/cEdge devices as these should come online and join the fabric (the always-on is pre-spun and nodes always connected), upon set-up. From the UI (vManage) how many devices are listed as WAN Edge.

 

Thanks!

Thank you very much for quick reply.

 

This is Cisco SDWAN 19.2 reserve sandbox, 

 

  • We cannot see any application data, or say we are not able to enable it because the required devices are powered OFF on sandbox. Please see below image, the devices vManage, vSmart and vBond are having green dot = power on

But others doesn’t have the green dot. Also, can’t see option to enable them, it might be issue from Cisco.

 

 

@shahid_jambagi i reserved a new SD-WAN sandbox (Fri 10 Dec 2021 11:58:48 GMT) it looks like the CML network simulation only starts part of the sd-wan topology. This would explain why we are not seeing WAN devices. Our ENG team will be taking this out of the reservation pool to fix this up. Please check back later.

 

Hope this helps.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers