NX-OS 9000

[NarenB]

Trying to set-up a simple topology using nxos9000 nodes and I see only three interfaces when using link connector to connect to other nodes. At one point I had seen more than that but lately I see only three interfaces. I need few more interfaces to create complete topology.

Has anyone else experienced same? Does anyone have a solution?

Thank you,

Naren

[bigevilbeard]

@NarenB whats this in CML, personal, ent, sandbox?

[NarenB]

CML

[bigevilbeard]

In the sandbox version?

[NarenB]

@bigevilbeard yes, in sandbox version. At one point there were 20 interface but after that I see only three to create "physical links".

[bigevilbeard]

Put a ticket into the team, if this was 20 before something then has changed --> HERE 

[balaji.bandi · Accepted solution]

by default it should offer you 20 interfaces, if you like more you can add as below :

https://developer.cisco.com/docs/modeling-labs/#!adding-interfaces-and-overprovisioning

[NarenB]

@balaji.bandi I need only 5 but I see only thee available Eth1/1-3

[balaji.bandi]

i was not sure on the sandbox, never used that should support it -  I was keener to address using the personal edition.

SANDBOX - that may be a limitation not sure.