cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1004
Views
0
Helpful
1
Replies

BAD_PARAMETER invalid cli command on 2960X switch stack

tyhill2014
Level 1
Level 1

Hello All,

I am working on provisioning a 2960X switch stack. This is a two switch stack. It is running 15.2.4(E6) IOS. When the stack boots up, it contacts the DNA Center as expected; however,  after the stack is fully discovered, the onboarding state errors with an initialization error 'BAD_PARAMETER invalid cli command'. Has anyone else run into this issue with provisioning a switch stack?


Thanks


Ty

1 Reply 1

tyhill2014
Level 1
Level 1

Found out yesterday from the TAC engineer that DNAC vers. 1.2 does not support 2960-X stacked switches. These switch stacks are supposed to be supported in DNAC vers 1.4 which should be available in August.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: