Discusiones Data Center

Foro Ask Me Anything (del 17 al 25 de agosto de 2023) Este foro está dedicado a las preguntas relacionadas con el webinar "Configuración y Troubleshooting de vPC", del pasado jueves 17 de agosto de 2023. Revisen la grabación, envíenos sus dudas o co...

Hello, what would be the config if I want to enable Jumbo frames for this requirement (see draw attached please). I want to enable jumbo frames among all 3 servers. The switch is a Nexus 93XX. Server 1 and 2 are on the same VLAN. Server 3 is on anoth...

Hello, we are migrating from 7K to 9K. In the current N7K we have this SPAN config: monitor session 1 source vlan 20 bothdestination interface Ethernet1/5no shut monitor session 2source vlan 20 bothdestination interface Ethernet1/6no shut   But when ...

Hi community, we currently have a NAM 2304 ver 6.2 device operating and the truth is that it is very useful, however it is completely outdated due to its version and the rest of the services that periodically alert the organization's security area.As...

I encounter a strange phenomenon of red channels on topology attach file in the past i open case and the engineer told me to clear counters/clear counters SNMP on all interface, but now the problem back again so i try my luck if someone here have a a...

Hello, ladies and gentlemen. I have a Problem, ISR4331/K9 + UCS E160S Module use, I tried to set CIMC by pressing F8 button when booting. Then, the problem occurred as shown in the link.     https://community.cisco.com/t5/discusiones-data-center/ucs...

Tengo 2 adaptadores SIOC en mi servidor de almacenamiento UCS S3260, en los que deseo realizar port channel para lograr redundancia, como debo hacer??

Cual es tu practica común cuando actualizas nexus 9000 en modo standalone, te gustaría aprender mas de como actualizar nexus 9000 en modo de mantenimiento ? saludos

Is there a document explaining the features included in the successive versions of ACI? And a document explaining the support periods they have?

I have configured QoS in two SWs, Nexus 3232 and Nexus 9336, the input policy is working ok, traffic is match wiht it, I can see packets inside it, but output policy isn't working, I can't see any packet that match in it, it is empty. This is the con...

I was working in the interconnection  N2K-C2248TP with N9K-C93180YC-FX, I could see the N2K in the N9K, when I type show  Fex I can see the FEX but in state down and never go up, I don't know they are compatible  or I need anything additional in the ...

Hi, I have connected a nexus 3232 with a optical transceiver 1Gb (I´m using a CVR-QSFP-SFP10G) to other Sw Cisco, on both side of the optical tranceivers I can see power in Tx and Rx, but the interfaces are down, I configured other  interface in the ...

Hi!The Cisco UCS C220 M4 support sip trunk?