Estimados
Tengo un problema en mi red empresarial, la empresa cuenta con dos sedes A y B, ambas sedes esta conectadas por una FIBRA de 10GB (SW_CORE_1 y SWCORE_EDIF2).
Sin embargo al comunicación entre ambas sedes es un poco lenta, cuando los usuarios de la sede B desean copiar alguna información compartida de la sede A, la copia nunca acaba y se termina cortando.
He notado que también se tiene perdida de paquetes.
copio la configuración de los puertos de ambos switch donde esta conectado la fibra para su apoyo:
SW_CORE_1#show interfaces gigabitEthernet 1/0/19
GigabitEthernet1/0/19 is up, line protocol is up (connected)
Hardware is Gigabit Ethernet, address is f40f.1bcb.0e93 (bia f40f.1bcb.0e93)
Description: SW_LOCALNEW_P5
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
reliability 255/255, txload 43/255, rxload 11/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 100Mb/s, media type is 10/100/1000BaseTX
input flow-control is off, output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:01, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 56461
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 4629000 bits/sec, 2199 packets/sec
5 minute output rate 17120000 bits/sec, 2638 packets/sec
122526764 packets input, 112420259176 bytes, 0 no buffer
Received 814896 broadcasts (143233 multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 143233 multicast, 0 pause input
0 input packets with dribble condition detected
114967517 packets output, 71347525602 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out
SW_CORE_1#
SWCORE_EDIF2#show interfaces gigabitEthernet 1/0/24
GigabitEthernet1/0/24 is up, line protocol is up (connected)
Hardware is Gigabit Ethernet, address is c4b9.cdcf.4a98 (bia c4b9.cdcf.4a98)
Description: Uplink to MPLSFORTINET
MTU 1500 bytes, BW 100000 Kbit/sec, DLY 100 usec,
reliability 255/255, txload 11/255, rxload 44/255
Encapsulation ARPA, loopback not set
Keepalive not set
Full-duplex, 100Mb/s, link type is auto, media type is 10/100/1000BaseTX SFP
input flow-control is on, output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 1142403267
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 17380000 bits/sec, 2664 packets/sec
5 minute output rate 4655000 bits/sec, 2199 packets/sec
4555690845 packets input, 3673194272688 bytes, 0 no buffer
Received 325445414 broadcasts (287406535 multicasts)
0 runts, 0 giants, 0 throttles
121 input errors, 109 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 287406535 multicast, 0 pause input
0 input packets with dribble condition detected
3886338854 packets output, 2308620539458 bytes, 0 underruns
1142403267 output errors, 0 collisions, 1 interface resets
0 unknown protocol drops
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 pause output
0 output buffer failures, 0 output buffers swapped out
SWCORE_EDIF2#
Los dos switch son del modelo 3850, me gustaría sus comentarios para poder ayudarme con este incidente, no se si es algo de configuración en los puertos, el cableado certificado o algo me esta faltando.
Saludos Cordiales
Miguel Flores
