Hello,
I would like to configure MACSEC between 2 6807-XL on fiber interfaces.
I can't find if:
- It is supported on C6800-16P10G modules, I knwo this is a replacement for old modules doing macsec but it is not written that it does macsec https://www.cisco.com/c/en/us/products/collateral/switches/catalyst-6500-series-switches/eos-eol-notice-c51-735926-fr.html
- I need a specific licence ?
- From a conf side, I want to do the following, is it a conf working if I want only macsec encryption and authent ? I don't know if I need to specify a policy:
Switch(config)# interface X/X
Switch(config-if)#cts manual
Switch(config-if)#sap pmk {pairwise-master-key} mode-list gcm-encrypt
Switch(config-if)#no propagate sgt
Switch(config-if)#shutdown
Switch(config-if)#no shutdown
Thanks,