cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1150
Views
0
Helpful
1
Replies

Add more outgoing IP's to C360

kasper.weng
Level 1
Level 1

I have 3 different Mail-server setups which all relays through my Ironport C360.

I have added the 3 different IP's in the "IP Interfaces" & "Listeners".

Each Mail-server setup connects to their own IP and it appears that all is working fine.

However when I check in the logs, all mail-servers connect on the proper IP, but relays the mail out on the first IP.

Anybody knows what I'm doing wrong here?

Thanks

Kasper

1 Reply 1

Bob Fayne
Level 1
Level 1

It sounds like you need to use the altsrchost command to set up Virtual Gateway mappings. You can specify that messages that match a source IP or a domain will be sent out using a specific interface. I believe altsrchost has to be done from the CLI and not the GUI.  The basic setup is pretty easy, map a specific sender IP or envelope sender domain to a specific interface to be used on exit.

Check out the section "Using Virtual Gateways" in Chapter 2 of the Advanced Configuration Guide as there are a lot of options that can be set up.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: