cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
350
Views
0
Helpful
2
Replies
Highlighted
Participant

Cisco ESA The overall memory swap usage (11%) has exceeded the configured threshold value of 10%.

Dear all. today i get such a message (The overall memory swap usage (11%) has exceeded the configured threshold value of 10%.  ) from ESA very often. could you please tell me what kind of issue it is? thanks in advance

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Cisco Employee

Re: Cisco ESA The overall memory swap usage (11%) has exceeded the configured threshold value of 10%.

Hi,

The swap alert received is informational alert. The system is designed to swap memory regularly, so some memory swapping is expected and is not an indication of problems with your appliance. Unless the system consistently swaps memory in high volumes, memory swapping is normal and expected behavior.

In order to stop such alerts, you can change the threshold value for the Memory Page swapping alert by following the below steps:

Log in to GUI-->System Administration-->System Health-->Edit Settings-->Memory Page swapping (Set the new threshold value, submit and commit the changes).

If the swap alert received the highest percentage the appliance generated is 11%, you can change the threshold to 15% after which won't receive any further alerts.

Cheers,
Pratham

View solution in original post

2 REPLIES 2
Highlighted
Cisco Employee

Re: Cisco ESA The overall memory swap usage (11%) has exceeded the configured threshold value of 10%.

Hi,

The swap alert received is informational alert. The system is designed to swap memory regularly, so some memory swapping is expected and is not an indication of problems with your appliance. Unless the system consistently swaps memory in high volumes, memory swapping is normal and expected behavior.

In order to stop such alerts, you can change the threshold value for the Memory Page swapping alert by following the below steps:

Log in to GUI-->System Administration-->System Health-->Edit Settings-->Memory Page swapping (Set the new threshold value, submit and commit the changes).

If the swap alert received the highest percentage the appliance generated is 11%, you can change the threshold to 15% after which won't receive any further alerts.

Cheers,
Pratham

View solution in original post

Highlighted
Participant

Re: Cisco ESA The overall memory swap usage (11%) has exceeded the configured threshold value of 10%.

Thank you so much