12-27-2016 06:45 AM
Hello
How to generate License File for virtual appliance and activate license on the new VESA ?
Thanks
Regards
12-27-2016 06:49 AM
You are supposed to be able to do it yourself on licensing.cisco.com. I have never had good luck, so I typically open a licensing ticket.
12-28-2016 12:29 PM
it never worked for me as well . simply open case with license team .
12-27-2016 07:14 AM
Hi Clement,
Details about the installation of a vESA can be found here:
http://www.cisco.com/c/dam/en/us/td/docs/security/content_security/virtual_appliances/Cisco_Content_Security_Virtual_Appliance_Install_Guide.pdf
And a guide how to install the license file you already received:
http://www.cisco.com/c/en/us/support/docs/security/email-security-virtual-appliance/118301-technote-esa-00.html
I hope these information helped.
Regards
Libin Varghese
12-27-2016 11:31 AM
Hello,
You'll want to follow the 'Obtain a VLN' instructions within this article : Best Practices for Virtual ESA/WSA/SMA License Installation
Once the physical license has been successfully shared with the vESA and you received your license, then you'll want to open up the XML file you received with NotePad++ or WordPad, select-all and then copy/paste into an SSH session using the loadlicense command.
If you have any problems during this process (which is common), then I would suggest opening up a licensing ticket and they should be able to assist you.
Thanks!
-Dennis M.
12-28-2016 12:32 AM
Thanks all
But when I finaly click on "Request Code" nothing happens.... too bad :/
Case opened
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: