cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
1581
Views
5
Helpful
2
Replies
marcelo89_138
Beginner

AMP for endpoints moves any device to the "None" policy automatically

Dear all,

 

When I do install AMP for endpoints in any device at the office, they're automatically are inserted into the "None" policy instead of the Windows Policy. This is a new thing, cos in the last months we didnt get this kind of results.

How can I do install AMP in a device and it goes straight to Windows Policy?

 

 

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Matthew Franks
Cisco Employee

Which installer are you using?  It should be linked to a policy.  When you download the connector from the. AMP Console under Management > Download Connector, you select a Group.  For each Group there are associated policies. For example, this Protect Group has the Protect Policy set for Windows connectors.

 
 
 

View solution in original post

2 REPLIES 2
Matthew Franks
Cisco Employee

Which installer are you using?  It should be linked to a policy.  When you download the connector from the. AMP Console under Management > Download Connector, you select a Group.  For each Group there are associated policies. For example, this Protect Group has the Protect Policy set for Windows connectors.

 
 
 

View solution in original post

It worked!

Thank you Matthew.

Create
Recognize Your Peers
Polls
Which of these topics should we host an event in the Community?

Top Choice: ISE Demo (100%)

Content for Community-Ad