08-15-2019 02:20 AM - edited 02-21-2020 09:24 AM
Hi all,
I have a 4110 cluster which I am trying to troubleshoot a load balancing issue.
Two commands that I see frequently applied to CCL and CDL port-channels are:
! int po1 desc CDL port-channel load-balance src-dst ip-l4port port-channel span-cluster vss-load-balance ! int po48 desc CCL port-channel load-balance src-dst ip-l4port !
Between the ASA contexts, FXOS CLI/ GUI where on earth do I apply the commands? Are they even required on a firepower chassis? If not what is the load-balancing hash used, src-dst-ip?
cheers,
Seb.
08-15-2019 07:34 AM
Are you running ASA or FTD image on your Firepower appliances?
08-16-2019 12:19 AM
Hi Marvin,
It is FXOS 2.1(1.85) running just an ASA image (9.1.7(4) ).
cheers,
Seb.
08-16-2019 07:37 AM
In FXOS we only create the Etherchannel and assign ports to it. Any configuration of the resultant Etherchannel is done from the ASA cli (or ASDM).
The default configuration is src-dst-ip as noted here:
08-19-2019 12:11 AM
That is what I though and thanks for the confirmation.
However from the CLI, when in the relevant context which has been allocated a port-channel, the configuration options I am presented with are quite limited. Certainly there is port-channel load-balance .
I think I may just configure the directly connected switches to src-dst-ip to get around this issue.
cheers,
Seb.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide