cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

257
Views
5
Helpful
1
Replies
Beginner

Adding more logical Devices from Chasis Manager

Hello,

 

image.png

Hello,

 

I can't add more Logical Devices, what do you think is the issue?

Is there a limit per license, how can I check that?

another question where do we set the this ip address? it's the chassis manager(Gui) interface address

image.png

 

Thx a lot

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Hall of Fame Guru

Re: Adding more logical Devices from Chasis Manager

Only on the 9300 series can one run multiple logical devices (if you have multiple Security Modules). The 4100 series only support a single logical device as a given time.

Changing the management address used by the chassis itself is done from the cli. See the following:

https://www.cisco.com/c/en/us/td/docs/security/firepower/fxos/fxos271/web-guide/b_GUI_FXOS_ConfigGuide_271/system_administration.html#task_2B7132B9D50D43A1B3BA0C585A36FD6A

While you can technically do it via ssh, I would recommend using the console port for this particular change.

View solution in original post

1 REPLY 1
Highlighted
Hall of Fame Guru

Re: Adding more logical Devices from Chasis Manager

Only on the 9300 series can one run multiple logical devices (if you have multiple Security Modules). The 4100 series only support a single logical device as a given time.

Changing the management address used by the chassis itself is done from the cli. See the following:

https://www.cisco.com/c/en/us/td/docs/security/firepower/fxos/fxos271/web-guide/b_GUI_FXOS_ConfigGuide_271/system_administration.html#task_2B7132B9D50D43A1B3BA0C585A36FD6A

While you can technically do it via ssh, I would recommend using the console port for this particular change.

View solution in original post