Can I enable Firepower 2100 interfaces using the CLI ?

[jimmycher]

I am configuring a Firepower 2120, using  an ISOLATED network (no internet access).  All I have is the console connection.  Can I use the FXOS CLI to enable interfaces, so that I can build and test it before shipping to a remote location?

[Francesco Molino · Accepted solution]

Hi
Officially you can't.
There's a backdoor you must use only under TAC supervision otherwise they won't support you by going into expert mode and using the tool /ngfw/usr/local/sf/bin/LinaConfigTool

[jimmycher]

Thanks for the reply.  It is a royal pain trying to configure this in a secure area, Cisco is making life difficult, not better.  Best