Can we use same crossover cable as Failover Link and State full Failover Link on Cisco asa5516 .

[kirti.116]

Can we use same crossover cable as Failover Link and State full Failover Link on Cisco asa5516 . I am not left with any extra port so can I use same port for both ?

[harmesh88 · Accepted solution]

Find information in below mentioned document

https://www.cisco.com/c/en/us/td/docs/security/asa/asa912/configuration/general/asa-912-general-config/ha-failover.html

[kirti.116]

Thanks harmesh

[harmesh88]

Dear ,

Find below mentioned URL for your reference 

https://www.cisco.com/c/en/us/td/docs/security/asa/asa912/configuration/general/asa-912-general-config/ha-failover.html

If will help you to understand your query .

[Marvin Rhoads · Accepted solution]

Yes you can use the same physical interface. I've done it many times with no problem.

[kirti.116]

Thanks Marvin