12-04-2017 08:38 AM - edited 02-21-2020 06:53 AM
Hi,
I have been working in the Lab on an HA pair of 2120 Firepower devices.
After Lab testing I have re-imaged both devices with the base install software package. Both boot successfully and I am presented with "firepower login:" prompt.
I can Login in to one of the devices using admin/Admin123 credentials. However I am unable to Login to the other device, as soon as I enter the admin username I am told that the Login is incorrect and immediately presented with the "firepower login:" prompt again with no option to enter the password.
Any suggestions would be appreciated to recover from this problem.
thanks
Ian
12-04-2017 10:55 AM
12-04-2017 11:09 AM
12-04-2017 11:16 AM
08-25-2020 01:25 PM
I had the same problem. The resolution was to Perform a Factory Reset from ROMMON. The guide as follows:
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: