01-30-2019 02:10 PM - edited 02-21-2020 08:43 AM
I have a Cisco FTD2110 managed by FMC running 6.2.3
I need to create a NAT policy that allows certain hosts on the internal network to reach specific destination IP addresses on the Internet, and be natted to a specific address. Can this be done within FTD? I don't see any option that allows it.
Solved! Go to Solution.
01-31-2019 12:58 AM
Hi,
Yes, you can able to do destination based NAT on FTD. Guide to configure NAT on FTD.
Hope This Helps
Abheesh
01-30-2019 04:05 PM
FTD nat rule are very similar to ASA code. only the difference is you have to config the nat rules from the GUI from the FCM. here is the link of ASA code easy to put your head around according to your needs.
01-31-2019 12:58 AM
Hi,
Yes, you can able to do destination based NAT on FTD. Guide to configure NAT on FTD.
Hope This Helps
Abheesh
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: