I have a customer currently running 6.2.2 FirePower code managed via FMC.
They have 2 separate circuits from the same ISP with different ranges and want Circuit1 connected to Primary and Circuit2 to Secondary so that, should a failover happen, they use the second circuit on the second firewall.
Is this possible?
If so then how might be the best way to implement it in regards to NAT/ACLS/Routes etc?
If not possible then how would be best to workaround so that it will work as a HA pair whilst retaining resiliency?
So you are planning to configure the FTD 2110 on High-availability and you have 2 ISP links.
As per your requirements i don't think so that is possible because your firewalls are on HA.
On HA, even if your firewall switch-over to the second firewall also it will take the Circuit1 IP to route the traffic outside.
Why can't you utilize both the links with the help of PBR. So when one of the link goes down also it will be swithover to the second circuit and you will get a full redundant network. Below is some video links to configure PBR.
We are happy to share changes to the Cisco Threat Grid support experience! Our customers have spoken, and we have listened! You want a single, streamlined, easy to access tool to open, view, and update your cases across Cisco Services. That tool is Cisco’...
Where can I find out how to integrate my Cisco products with Threat Response?
There are quick start guides and instructional videos to help you get set up with your Cisco products and the Cisco Threat Response platform.
Inviting all Security & Networking professionals! We want you to tell us what devices you use to do your work and its screen resolution. Your response will help us improve network and security management tools.
Click here to take the 5-minute s...
This guide is intended to show some nifty and powerful use cases that a lot of customers either want or don’t know they want. There are tons of other content out there for specific knobs or capabilities, but this is looking to be a more complete...