cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
319
Views
0
Helpful
4
Replies
Beginner

FirePower2110 interface error and ping issue

hello, Now, we deploy the FirePower2110 to replace ASA5525, we find the following situations, from the AScentlink,we can ping pass 10.229.31.17(primary device firepower 2110), but from 2960 switches(connect the internet) ,we can't ping pass 10.229.31.17. What is more confusing,from the 2960, we can ping pass the 10.229.31.18(secondary device firepower 2110). Other confusing, the FMC has the following the alarm at the same time in figure 1,the topology is figure 2. other question,I want to know where can i configure the SSL VPN in FMC 6.2.2?
4 REPLIES
Highlighted
Beginner

Re: FirePower2110 interface error and ping issue

Looking forward to your reply, thank you!
Hall of Fame Master

Re: FirePower2110 interface error and ping issue

I'm not sure about your pinging issue. It could be any number of things depending on your switch and routing setup.

 

Re the SSL VPN, you configure it under Devices > VPN > Remote Access.

 

FMC SSL VPN.PNG

Beginner

Re: FirePower2110 interface error and ping issue

hi Rhoads, we check the switch and other device, but they have no problem. The FMC has the alarm."the interface E1/4 is not receiving any packets" Thank you
Hall of Fame Master

Re: FirePower2110 interface error and ping issue

The FTD in the alarm is listed as 10.229.20.31. That address doesn't appear on your network drawing.

 

If it is indeed the same as FTD_01 on your drawing, what does the connected switchport on 2960_01 (gi1/0/22) indicate? Is it sending packets?

CreatePlease to create content
Ask the Expert- Webex Hybrid Services Solutions