cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

278
Views
5
Helpful
2
Replies
Highlighted
Participant

FPR 2110 | ASA OS Upgrade

Hello, 

 

We have a few FPR2110s and running the ASA code on them. I am planning to upgrade the ASA OS code from 9.8.2 to 9.8.4; however, when I issue the dir disk and dir flash commands at the asa cli the current os is not listed. Also, when I issue the "show running-config boot system" this command isn't available. I resorted to issuing "show boothvar" and the parameters didn't have any values.

 

My questions are, why is the OS not listed when issuing "dir disk" or "dir lash:"? Also, what is the ASA OS procedure when configured in FO when running the ASAs on the FPR2110s?

 

Thanks in advance,

~zK

 

Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions
VIP Advocate

Re: FPR 2110 | ASA OS Upgrade

You would use the Firepower Chassis Manager or FXOS CLI to upgrade an ASA OS running on the Firepower 2100. The procedure is given here:

 

https://www.cisco.com/c/en/us/td/docs/security/asa/upgrade/asa-upgrade/asa-appliance-asav.html#id_57757

2 REPLIES 2
VIP Advocate

Re: FPR 2110 | ASA OS Upgrade

You would use the Firepower Chassis Manager or FXOS CLI to upgrade an ASA OS running on the Firepower 2100. The procedure is given here:

 

https://www.cisco.com/c/en/us/td/docs/security/asa/upgrade/asa-upgrade/asa-appliance-asav.html#id_57757

Participant

Re: FPR 2110 | ASA OS Upgrade

Thank you, sir! That's exactly what I was looking for!

 

Best, ~zK