03-04-2018 05:45 AM - edited 02-21-2020 07:28 AM
here are the design issues that i found so far
i really need a soln to import CLI, rather than just use the limited GUI- a bug bug
if i could import, then i could fix and get my old config into the new CLI format
i can get a running config from the CLI, i cant enter and config command
with current gui, there is a lot of missing functionality
Solved! Go to Solution.
03-04-2018 07:37 AM
Hello Walter,
Unfortunately there is no support for conf t on FTD. Even if you were to remove it from the Manager.
It seems that you would be better served by keeping the ASA-SFR module combination instead of using FTD.
FTD does not have full functionality parity with ASA yet.
03-04-2018 07:33 AM
03-04-2018 07:37 AM
Hello Walter,
Unfortunately there is no support for conf t on FTD. Even if you were to remove it from the Manager.
It seems that you would be better served by keeping the ASA-SFR module combination instead of using FTD.
FTD does not have full functionality parity with ASA yet.
03-04-2018 07:41 AM
03-04-2018 07:46 AM
03-04-2018 08:31 AM
03-04-2018 11:31 AM
03-05-2018 04:22 AM
Hello Walter,
Please see the screenshot below.
EIGRP is not under the routing tab of the device, but it can be configured by using Flex Config.
Devices > FlexConfig.
Regarding security level, there is no concept of that on FTD, the access control rules are what is used to get traffic from one interface to the other.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: