Need assistance on How to add Protect and Control license to Standby units using ASDM.

[orthicon2009]

Hi Everyone,

I have setup TWO 5525-X and are currently configured as HA. I need some assistance on how to add Protect and Control license to the Standby unit using ASDM.

I've already setup the license for the primary but when I deployed the policy it gives me an error saying "This rule requires a protection license, but the device does not have a protection license."

Attached is the screenshot of the error and the license that is activated in the primary.

Thanks,

Orthicon

[orthicon2009]

Here's the other screenshot. Thanks.

[orthicon2009]

Hello Cisco Experts!

I was able to add the license on both firewalls but still getting the error  when I apply the control policy.

"Error: This rule requires a Protection license, but the device does not have a Protect license"

Need some help on how to solve this problem.

Thanks.