cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

439
Views
0
Helpful
2
Replies
Highlighted
Beginner

PBR on FTD

I configured route-map on FMC, then I configured a text object as a next hop for the PBR.

I used this object in the Flex configuration, for the PBR, and everything was fine, after deployment I checked the configuration on the FTD, but something weird happens, the configuration has been applied as below

 

route-map Test_PBR permit 10
match ip address PBR_ACL
set ip next-hop peer-address

 

so I checked the deployment history, and error appears in the deploy transcriot

ERROR: Peer-address and specific IP address can not be mixed.

any help.

Thank you all in advanced.

 

Everyone's tags (3)
2 REPLIES 2
Rising star

Re: PBR on FTD

This Video show how to configure PBR using FMC FlexConfig. Correction: During Flex-Configuration, instead of applying Route-map on Ethernet 1/1 & Ethernet 1/3 which is outside. It should be applyed on Ethernet 1/2 (Inside Interface). Linkedin: https://www.linkedin.com/in/nandakumar80/
Beginner

Re: PBR on FTD

Dear Sheraz.Salim,

This is another problem and I already checked the attached video, all configuration is done like the video but the output on the device is different.

 

Thank you in all cases.