05-28-2019 06:07 AM - edited 02-21-2020 09:10 AM
I configured route-map on FMC, then I configured a text object as a next hop for the PBR.
I used this object in the Flex configuration, for the PBR, and everything was fine, after deployment I checked the configuration on the FTD, but something weird happens, the configuration has been applied as below
route-map Test_PBR permit 10
match ip address PBR_ACL
set ip next-hop peer-address
so I checked the deployment history, and error appears in the deploy transcriot
ERROR: Peer-address and specific IP address can not be mixed.
any help.
Thank you all in advanced.
05-28-2019 07:00 AM
check this link similar issue.
https://community.cisco.com/t5/firepower/pbr-on-ftd/td-p/3327116
https://www.youtube.com/watch?v=lakHhw9CR5Y
05-28-2019 07:39 AM
Dear Sheraz.Salim,
This is another problem and I already checked the attached video, all configuration is done like the video but the output on the device is different.
Thank you in all cases.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide