cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
95
Views
0
Helpful
1
Replies

Rate limiting on FTD

Hi All,

 

Can we Rate limit/Bandwidth restriction on the traffic based on the physical interface of firepower with FTD image.

Regards

Binay 

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Hall of Fame Master

Re: Rate limiting on FTD

Yes. The feature has been around for several years.

Here's a link to the configuration guide section covering how to do it on the latest release (6.4):

https://www.cisco.com/c/en/us/td/docs/security/firepower/640/configuration/guide/fpmc-config-guide-v64/quality_of_service__qos__for_firepower_threat_defense.html#id_16325

Note the feature is NOT available for traffic that has been fastpathed with a prefilter policy rule.

1 REPLY 1
Highlighted
Hall of Fame Master

Re: Rate limiting on FTD

Yes. The feature has been around for several years.

Here's a link to the configuration guide section covering how to do it on the latest release (6.4):

https://www.cisco.com/c/en/us/td/docs/security/firepower/640/configuration/guide/fpmc-config-guide-v64/quality_of_service__qos__for_firepower_threat_defense.html#id_16325

Note the feature is NOT available for traffic that has been fastpathed with a prefilter policy rule.