Unable to communicate with dynamic analysis cloud

[Mark^]

I have two interfaces on Defense Center.  One of them (eth1) is on a management vlan that does not have Internet access.  When AMP tries to connect to cloud it frequently tries via eth1 and I get the above message and a health monitoring alert.  I know this is the cause because it shows the IP address of eth1 in the message and, as I said, eth1 does not have Internet access.

How do I force updates to only use eth0?  My default route is on eth0 network.

[Mark^]

I am actually getting a similar message when eth1 is not present, though it is less frequent.

[jlimmer14]

did you ever find an answer?

[Mark^]

Negative, but I think I misunderstood the problem in the first place.  I am now on 6.0 and get the message once in a while, but it never causes a health monitoring alert and doesn't seem to cause any other issue.