cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to Cisco Firewalls Community


253
Views
0
Helpful
6
Replies
Beginner

2110 Static Route

New NGFW user here. 

 

In the Juniper World, I have a simple static route:

route 10.8.0.0/24 next-hop 10.1.1.90;

 

(10.8.0.x is the IP used by my VPN server and handed to the client) and 10.1.1.90 is the IP of my VPN server. Since 10.8.0.x doesn't live on my network)

 

I am struggling to get this route added:

 

> show interface inside
Interface Ethernet1/2 "inside", is up, line protocol is up
Hardware is EtherSVI, BW 1000 Mbps, DLY 10 usec
MAC address 5c71.0de7.e8ed, MTU 1500
IP address 10.1.1.1, subnet mask 255.255.255.0

 

> configure network static-routes ipv4 add inside 10.8.0.0 255.255.255.0 10.1.1.90
Error: Interface supplied (inside) is either not yet configured or does not exist.


> configure network static-routes ipv4 add Ethernet1/2 10.8.0.0 255.255.255.0 10.1.1.90
Error: Interface supplied (Ethernet1/2) is not valid.

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Advisor RJI VIP Advisor
VIP Advisor

Re: 2110 Static Route

What is the error then? Provide a screenshot

You have to add the routes using the GUI for the data interfaces.

View solution in original post

6 REPLIES 6
VIP Advisor RJI VIP Advisor
VIP Advisor

Re: 2110 Static Route

Hi,
The CLI is only used to configure the management interface, you would configure the data interfaces using either the built in local WebGUI (FDM) or if managed centrally, the FMC.

 

If you are using FDM manage the FTD local this guide should help. Define the management IP and default gateway, configure management type as local and then connect to the WebGUI to configure the firewall.

 

HTH

Beginner

Re: 2110 Static Route

I have it working. DHCP Pool, Inside and outside interface, Just need that static route in place. 

Highlighted
VIP Advisor RJI VIP Advisor
VIP Advisor

Re: 2110 Static Route

So you are using FDM? If so login to the FDM GUI, go to the Routing summary page and create a static route. Link to guide.

Beginner

Re: 2110 Static Route

The GUI doesn't allow me to add it. So I tried with the CLI. I hate the CLI interface, not like a normal Cisco device.

 

Just need to add a 1 static route.  

VIP Advisor RJI VIP Advisor
VIP Advisor

Re: 2110 Static Route

What is the error then? Provide a screenshot

You have to add the routes using the GUI for the data interfaces.

View solution in original post

Beginner

Re: 2110 Static Route

Thank You, Amazing what a new day of sleep does for you.

 

I got it in there. I had to add the Network and Gateway IP address:

Capture.PNG

CreatePlease to create content
Content for Community-Ad
FusionCharts will render here