Access problem from Inside to DMZ and outside to DMZ
So long time lurker, first time poster. These FTD firewalls are making me feel like a greenhorn again. I've slogged through the initial configuration, have interfaces and etherchannels finally working... but cannot for the life of me configure access from our inside networks to our DMZ. I configured NATs in the vein of our configuration on the older ASA5525s without success.
Re: Access problem from Inside to DMZ and outside to DMZ
The Access-rules should be similar to what you have on the ASA version 8.3+. You do not need a NAT to go from inside to DMZ. You can however add a NAT exempt to exempt inside to DMZ traffic from any translation.
DMZ to outside would require an Auto NAT rule. Also, an ACL would be needed from Outside to DMZ to allow internet users to access your public DMZ servers.
It would be good if you can show us an example of what you have configured and what is not working.
Threat Response Basics
What is Threat Response and how can it help my organization?
What is the cost of Threat Response?
What are the deployment options for Threat Response?
Is Threat Response available outside of the United States?
Gartner has once again named Cisco a Leader in the Magic Quadrant for Network Firewalls. This distinction recognizes Cisco's ingenuity in redefining the firewall as the basis for an integrated security platform.
Find out how Cisco stands out from the comp...
Hi experts,I would like any suggestions on this topology. We are is the middle of replacing our old ASA5520 with the new FirePower. Our current firewall terminate our IPsec tunnels and the GRE is terminated on the first inside router's loopback on the sec...
Hi All, A customer wants to authenticate Anyconnect VPN users from an ASA using the client installed certificate and then with AD. i.e. Is this a corporate device?Would we recommend authenticating the cert on the ASA then passing the AD check to ISE ...
Hello Team, we are getting alert in FMC stating policy deployment failed, we are running on 6.2.0 version and not sure which version is stable version to re mediate this issue, in one event i have seen restart will resolve this issue but is it perman...