cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to Cisco Firewalls Community


339
Views
0
Helpful
3
Replies
Beginner

active/standby in multiple context mode

is active/standby configuration possible in multilple context mode? i cannot find an article regarding this matter.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: active/standby in multiple context mode

Hello John,

It is available

Actually the ones you need are the regular  ones (documents) as the ASA will trigger failover if one of the context fail

Important Notes

For multiple context mode, the ASA can fail over the entire unit (including all contexts) but cannot fail over individual contexts separately.

. Active/Standby Failover is available on units that run in either single or multiple context mode. Both failover configurations support stateful or stateless (regular) failover.

VPN failover is not supported on units that run in multiple context mode as VPN is not supported in multiple context. VPN failover is available only for

Active/Standby Failover configurations in single context configurations.

With this I think you are ready to start configuring it:

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00807dac5f.shtml

Julio

Julio Carvajal
Senior Network Security and Core Specialist
CCIE #42930, 2xCCNP, JNCIP-SEC

View solution in original post

3 REPLIES 3

Re: active/standby in multiple context mode

Hello John,

It is available

Actually the ones you need are the regular  ones (documents) as the ASA will trigger failover if one of the context fail

Important Notes

For multiple context mode, the ASA can fail over the entire unit (including all contexts) but cannot fail over individual contexts separately.

. Active/Standby Failover is available on units that run in either single or multiple context mode. Both failover configurations support stateful or stateless (regular) failover.

VPN failover is not supported on units that run in multiple context mode as VPN is not supported in multiple context. VPN failover is available only for

Active/Standby Failover configurations in single context configurations.

With this I think you are ready to start configuring it:

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00807dac5f.shtml

Julio

Julio Carvajal
Senior Network Security and Core Specialist
CCIE #42930, 2xCCNP, JNCIP-SEC

View solution in original post

Beginner

Re: active/standby in multiple context mode

got it. thanks. i was able to configure it and it was successful. thanks. appreciate it.

Re: active/standby in multiple context mode

Hello John,

My pleasure

Regards,

Julio Carvajal
Senior Network Security and Core Specialist
CCIE #42930, 2xCCNP, JNCIP-SEC