AnyConnect is not enabled on the VPN server

[lcaruso]

I'm trying to configure remote access vpn. I can connect from my web browser and login fine.

When I use the AnyConnect client, after entering in the ip address and port number, I get prompted about the certificate warning, I get prompted for my username and password, and after entering my password, I'm getting the message

AnyConnect is not enabled on the VPN server

How do I enable AnyConnect in the remote access vpn setup? I'm doing this all from CLI only.

[lcaruso]

svc enable

[Diego Armando Cambronero Arias]

post the config

[lcaruso]

Thanks for your interest. I've narrowed it down: the particular user is not enabled for svc. Once I enable this user, it should be good.

[andamani · Accepted solution]

Hi,

Why don't enable the group-policy and  tunnel-group for anyconnect. this way the user specific issues can be  eliminated.

The following link gives you all the  details of the configuration:

http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a00808efbd2.shtml

Regards,

Anisha

-  Do rate helpful posts.

[lcaruso]

Thanks for link.

[JoshThurston9204]

link gets a 404 error message.

[Marvin Rhoads]

@JoshThurston9204 wrote:

link gets a 404 error message.

---

That's because the original thread is 8 years old.

If you want a current example of SSL VPN setup on an ASA, please see this one:

https://www.cisco.com/c/en/us/support/docs/security/anyconnect-secure-mobility-client/119006-configure-anyconnect-00.html

There are many more also available for more specific use cases.

https://www.cisco.com/c/en/us/support/security/asa-5500-series-next-generation-firewalls/products-configuration-examples-list.html

https://www.cisco.com/c/en/us/support/security/anyconnect-secure-mobility-client/products-configuration-examples-list.html

If you have specific questions, please start a new discussion.

[salehnoordeen]

Hi

  Can you please post the command you used to enable svc for that particular user?

Thanks