i have a new ASA 5520 with only factory default settings. I ran the commands below on the CLI as instructed for a Cisco document but i cannot access it via https://192.168.1.1/admin like it says i should be able to.
Step 1 To identify the IP addresses from which the security appliance accepts HTTPS connections, enter the following command for each address or subnet:
hostname(config)# http source_IP_address mask source_interface
Step 2 To enable the HTTPS server, enter the following command:
hostname(config)# http server enable
Step 3 To specify the location of the ASDM image, enter the following command:
hostname(config)# asdm image disk0:/asdmfile
when i ran step 3 i got a printout of Device manager image set, but unable to find disk0: /asdmfile??
any help ?
Solved! Go to Solution.
Check "sh disk0:" to see if you have an ASDM image. And then point to it with the "asdm image " command. Make sure there are no typos.
If there is no image, you need to copy it to disk0: from a tftp server.
Make sure you use an image compatible with your ASA. 8.0 and 8.2 can work with ASDM 6.2.
I hope it helps.
That means the image is correctly set and is pointing to 621.bin. Now, when you try to access the asdm, do you see any error message?
Also, what is the java version you are running on your machine?
when trying https://192.168.1.1/admin
it just comes back with The connection has timed out the sever at 192.168.1.1 is taking too long to respond. my current java version is
Are you able to ping 192.168.1.1? What is the ip address of your machine? Can you give me the output of "sh run http"?
i ran command " http 192.168.1.0 255.255.255.0 management " still with no success. i can still ping the box just cannot access via web browser