cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to Cisco Firewalls Community


206
Views
0
Helpful
0
Replies
Beginner

ASA Anyconnect disconnects and reconnects Outside port errors

We had a few users complain about disconnects and reconnects.  We have on average about 500 people who connect to the anyconnect on our ASA 5555.

 

While looking for a reason we discovered that the Outside interface has some errors and overruns on it.  We do not have flow control turned on.  Could this be a reason why we might have a few users showing disconnects and reconnects?  

 

Interface GigabitEthernet0/0 "", is up, line protocol is up
Hardware is i82574L rev00, BW 1000 Mbps, DLY 10 usec
Auto-Duplex(Full-duplex), Auto-Speed(1000 Mbps)
Input flow control is unsupported, output flow control is off
Description: External Client Data
Active member of Port-channel1
MAC address cc46.d6f8.4c39, MTU 1500
IP address unassigned
305036353232 packets input, 200800159375818 bytes, 0 no buffer
Received 540722 broadcasts, 0 runts, 0 giants
38028648 input errors, 1 CRC, 0 frame, 38028647 overrun, 0 ignored, 0 abort
0 pause input, 0 resume input
0 L2 decode drops
146520215511 packets output, 99195296755085 bytes, 0 underruns
0 pause output, 0 resume output
0 output errors, 0 collisions, 0 interface resets
0 late collisions, 0 deferred
0 input reset drops, 0 output reset drops
input queue (blocks free curr/low): hardware (491/321)
output queue (blocks free curr/low): hardware (511/0)

Everyone's tags (2)