01-01-2009 10:10 PM - edited 03-11-2019 07:31 AM
What is the use of service internal command? How to use it?
01-02-2009 04:56 AM
This command should only be used with the assistance of Cisco TAC.
HTH>
01-02-2009 05:00 AM
Hi Andrew,
Thanks for your reply. I just wanted to know the use of this command.
Regards
01-02-2009 07:43 AM
That is the actual output from a firewall when you enter the command. There is no reference I can find in an command lookup that explains the command.
So honestly if you need to know/use the command - open a TAC case.
HTH>
01-02-2009 07:10 AM
The service internal command unlocks many commands for internal testing. Having this configured will allow many undocumented commands that you would not normally see. You really shouldn't use the command without guidance from TAC as there could be some negative consequences on the equipment and/or production network.
HTH,
Mark
01-03-2009 06:33 AM
Hi,
Thanks for your response. So we don't have any doc which gives info about the command.
Regards...
01-04-2009 02:49 PM
This is an undocumented command and have yet to see any documentation regarding it.
Mark
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: