cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to Cisco Firewalls Community


560
Views
0
Helpful
1
Replies
Highlighted
Beginner

ASA config standardization commands

Hi,

In order to standardized/secure the ASA configurations, I am going to deploy the attached commands to several ASA from version 8.0 to 8.4. Although I have tested them and they work ok, but as precaution please advice that these commands will not delete ssh/ telnet/ http from ACL/NAT etc.

Also please advise that these commands will also work in PIX 6.3.

You response will give confidence before deployment and also help many others.

Thanks

Everyone's tags (3)
1 ACCEPTED SOLUTION

Accepted Solutions
VIP Advocate

The clear configure http and

The clear configure http and clear configure ssh will not remove any of the NAT or ACL statements.

I have not worked much on PIX, but I believe that the commands will also work with it.  The only exception is the enabling of logging which I believe is done using logging on command.

Other than that it is very common for these commands to be configured on all ASAs.

 

--

Please remember to rate and select a correct answer

--
Please remember to rate and select a correct answer
1 REPLY 1
VIP Advocate

The clear configure http and

The clear configure http and clear configure ssh will not remove any of the NAT or ACL statements.

I have not worked much on PIX, but I believe that the commands will also work with it.  The only exception is the enabling of logging which I believe is done using logging on command.

Other than that it is very common for these commands to be configured on all ASAs.

 

--

Please remember to rate and select a correct answer

--
Please remember to rate and select a correct answer