06-18-2019 04:28 AM
Hi there,
I would like to configure syslog, so I get only Allow and Deny from the ACL.
I tried to configure an Event List with some Message ID's. But the logging seemed not to be the selected ID's, but * a lot * more.
Any pointers?
regards Nikolaj
06-18-2019 06:50 PM
Hi there! Please have a look at the link below. It is an older document but still useful:
https://www.cisco.com/c/en/us/td/docs/security/asa/asa84/configuration/guide/asa_84_cli_config/acl_logging.pdf
I hope this helps!
Thank you for rating helpful posts!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: