cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1268
Views
0
Helpful
0
Replies

ASA5506-X FirePower module 6.2.2-81 Access Control Policy missing after licensing.

cvpoolec1
Level 1
Level 1

Cisco Adaptive Security Appliance Software Version 9.8(2)28
Firepower Extensible Operating System Version 2.2(2.79)
Device Manager Version 7.8(2)

 

I just installed an initial firepower control license for firepower; along with Malware and URL Filtering. The firewall is managed through ASDM and is communicating with the firepower module, however, when I click on the Access Control Policy tab I receive a message stating that the policy either does not exist or has been deleted.

 

I am at the beginner stage with Linux commands however I am able to access the sfr module through cli. Can someone help with this? I am posting the sfr session output below:

 

> show access-control-config
Access control policy not yet applied.

> show network
===============[ System Information ]===============
Hostname : firepower
Domains : example.net
Management port : 8305
IPv4 Default route
Gateway : 10.X.X.3

======================[ eth0 ]======================
State : Enabled
Channels : Management & Events
Mode : Non-Autonegotiation
MDI/MDIX : Auto/MDIX
MTU : 1500
MAC Address : B0:8B:CF:03:E8:43
----------------------[ IPv4 ]----------------------
Configuration : Manual
Address : 10.X.X.1
Netmask : 255.255.255.0
Broadcast : 10.X.X.255
----------------------[ IPv6 ]----------------------
Configuration : Disabled

===============[ Proxy Information ]================
State : Disabled
Authentication : Disabled

>
> Console session with module sfr terminated.
PSFR-5506X# sh moduel sfr
^
ERROR: % Invalid input detected at '^' marker.
PSFR-5506X# sh mod sfr

Mod Card Type Model Serial No.
---- -------------------------------------------- ------------------ -----------
sfr FirePOWER Services Software Module ASA5506 JAD22250L3H

Mod MAC Address Range Hw Version Fw Version Sw Version
---- --------------------------------- ------------ ------------ ---------------
sfr b08b.cf03.e843 to b08b.cf03.e843 N/A N/A 6.2.2-81

Mod SSM Application Name Status SSM Application Version
---- ------------------------------ ---------------- --------------------------
sfr ASA FirePOWER Up 6.2.2-81

Mod Status Data Plane Status Compatibility
---- ------------------ --------------------- -------------
sfr Up Up

 

Clay Poole
Network Engineer
0 Replies 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: