11-19-2012 01:19 PM - edited 03-11-2019 05:25 PM
Folks,
I have an asa5520 runing 9.0 that I want to setup for simple NAT, i,e 4.3.2.1/30 on the outside 192.168.1.1/24 on the inside with dynamic NAT outbound. The new IOS has thrown me for a loop.. I have everything working except the NAT. Can somebody do an SDM screen shot of the Dynamic NAT entry? Even if the IP's are different, I can figure it out...
Also, is there a way to make the unused ethernet interfaces gig0/2 and 0/3 into switch ports on the internal net?
(or VLAN like you could do on the 5505)?
11-19-2012 07:40 PM
Hello,
This Guide should help you:
for internet access, look at "Configuring Dynamic PAT (Hide)" Section.
Regards,
Felipe.
11-19-2012 07:44 PM
Also, you cannot use the interfaces as switchports, this is possible only on the ASA5505.
Regards,
Felipe.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide